I built a new customized pool about a year ago and now I am having issues with the surface of the pool becoming rough. I recently checked my pool pH which was found to be 7.8. I did acid wash thrice last year. What could be the reason for such a roughness? What can be done to avoid the roughness?
You need to be a member of Pool Genius Network to add comments!
If you are a member of the "pool industry" community, you have found your home.
This is a network of pool builders, service professionals, retailers, and pool sales reps,…
Swimming pools are often associated with luxury, relaxation, and endless summer fun. But there's more than just the allure of crystal-clear water that leads a…
The Journal of the Swimming Pool and Spa Industry is coming back! JSPSI, a peer-reviewed technical journal, began in 1995 as a subscription-supported print-based publication. It contained articles at a technical…
All pool plaster finishes should last 20 years or more. However, some last only 5 to 7 years, and some less than a year before the plaster surface deteriorates, discolors, and looks terrible.
Why the difference? Very often, plaster…
For 50 years, the pool industry has considered pool water within an LSI of -0.3 and +0.5 to be acceptable and balanced. But recently, and without providing any supporting science or research, the NPC is trying to convince the industry that any…
There are two important issues involved when trying to achieve quality colored pool plaster that will remain durable, attractive, and the proper shade for many years.
The first issue is to utilize superior workmanship practices to achieve…
Replies
Also.. A great trick is to put in a extra sweep you might have so it picks up all the fine dust.
( for future THIS IS IMPORTANT.. if you don't brush a pool that has gravel, or sandstone dust.. IT WILL ALWAYS BOND OVER TIME TO THE PLASTER OF YOUR POOL.
(I turn the pool controls to spa drain and brush all the dirt to the drains. Or use a fine mesh net and or will take my clients sweep.. Remove the sweep head and connect it to a my Vacuum head.( If you don't have enough links ( aka. Doesn't reach), I always carry and attach to my own to my clients sweep links and use a few ( good luck)
Hello friend,
Normal pH suggested for pools is 7.4 . If you don’t mind the Chlorine level there will scaling of pools. Rough surface is all about water balance. Regular maintenance and water refilling should be done. Make sure you refill it every 3 months. For more approach any experts in this field. They may help you with know-how on maintenance of pools. Try with Ferrari pools, patios and spas a pool renovation services (http://www.ferraripools.com/pool-service-maintenance/ ). Hope to see your pool prob fixed soon. Do post your status.
The roughness should be sanded down to smooth and incress calcium to 250 ppm
Check your total alkalinity for starters.
Check your calcium level. Calcium hardness minimum levels should 250 ppm. There's a good chance the calcium is being "pulled" from the plaster and leaving a rough surface.
Avoiding these issues begins prior to the initial filling of the pool upon completion.
The water source to be used should be tested so you be can ready to treat immediately.
Careful monitoring over a 2 week period is critical.